tank fires

tbmoore · Post by **tbmoore** » Thu Jul 15, 2004 7:52 am

Just a leg up here......I have had two X=ten modules go up in smoke....one was a water dripping on it and it went off like a firecracker....the other was a loose wire and it was a slow burn...
No problems so far but a heads up to do a quality ck on your wireing.

danielmiller82 · Post by **danielmiller82** » Thu Jul 15, 2004 10:29 am

how much does an automated x10 system like that cost? Ive been thinking I will get one when I setup my big tank. Does yours have a software interface that works with multiple tanks? I have an old 300mhz PC that I was gunna use to run a webcam of the tank, I could use that for an x10 system as well!

tbmoore · Post by **tbmoore** » Thu Jul 15, 2004 11:28 am

I am using an octopus 3000 but if I had it to do over again I would go to an aqua system because of the system support.

SaltnLime · Post by **SaltnLime** » Mon Jul 19, 2004 9:01 pm

tbmoore wrote:Just a leg up here......I have had two X=ten modules go up in smoke....one was a water dripping on it and it went off like a firecracker....the other was a loose wire and it was a slow burn...
No problems so far but a heads up to do a quality ck on your wireing.

Xster · Post by **Xster** » Tue Jul 20, 2004 12:51 am

Wowser!

Post by **snoopdog** » Tue Jul 20, 2004 5:41 pm

They are extremely expensive when you get everything including extra modules. Unless you have alot of money to spend and want to put it into the tank i would not recommend it.

tank fires

tank fires

Re: tank fires