Page 1 of 1
DIY Question
Posted: Sun Feb 27, 2005 9:07 pm
by Phisher
My tile floors (or slab) are not very level and I have a high spot about 10" from the center of where my new stand will be sitting. I can shim the low side and make it level I'm just worried about the weight on the shims.
Does anyone think this will be ok or is it a bad idea.
Joe
Posted: Sun Feb 27, 2005 9:59 pm
by Brandon
Well, if it were going to crush your shims, it would probably crush the stand which is probably made of wood. My floor was unlevel at the last house and I used linoleum tiles to level the stand, I figured it was spread out more than shims would be.. worked fine, but I would think shims probably would also.
Posted: Mon Feb 28, 2005 5:14 am
by tbmoore
I have loads of shims under my 240......been 2yrs....
Posted: Mon Feb 28, 2005 6:50 am
by Phisher
Thats cool. Xster said he has shims under his also so I should be ok.
Joe
Posted: Mon Feb 28, 2005 9:29 am
by ShagMan
Yep, everybody uses shims, no worries... only worry you would have is to make sure you don't shim over a hollow tile, that would be bad!!!