Page 3 of 4
Posted: Fri Jul 08, 2005 10:23 pm
by Brandon
Wouldn't you probably save as much as a service call costs in a month to get your system checked out.

Posted: Sat Jul 09, 2005 1:11 am
by ShagMan
been there, done that, we did it once when it was still under warranty... it's cold, but it doesn't cool down the house... tonnage is right... we're thinking the attic isn't venting properly... I have on my to-do list to get some temp guages and check the attic temps on a hot day.
Posted: Sat Jul 09, 2005 9:41 am
by snoopdog
You could always try an electric attic fan.
Posted: Sat Jul 09, 2005 9:59 am
by Phisher
Actually medium and large tanks dramatically change the heat load on a room/house. The room where my 75 was was always hot-thought it was the large south facing window. I had the airbalance crew from work come in, said heat load was correct and airflow was correct. They advised me to move a duct from the living room into that room. I did not make any changes but moved the 75 out and put the 120 in the living room. Now this summer the back bedroom is the most comfortable room in the house but the living room is hot.
When a contractor runs a heat load on a house the appliances are taken into consideration. In my estimate a reef tank should be calculated something like a 1 close drier that runs 24/7 per 100-150g because of the heat and humidity it puts out.
I am experimenting with a small dehumidifier now. I keep it set low, does not come on at all during the day because the air runs so much but it pulls about a gal a night out between 12-6am.
Joe
Posted: Mon Jul 11, 2005 9:16 am
by ShagMan
I use a 70 pint dehumidifier on and off... even set to it's lowest setting (70%) it runs 24/7... fills the container in about 12-16 hours.
Posted: Mon Jul 11, 2005 12:51 pm
by snoopdog
The guy "weatherson" had the right idea by pumping the heat from his light strip into the attic then back out of the house.
Posted: Mon Jul 11, 2005 2:37 pm
by Jahdiel
UHM

Posted: Mon Jul 11, 2005 2:39 pm
by Jahdiel
Interesting you say that snoopdog. I just asked Billy when we put the tank in the wall, Why not put one of those vents like in the bathroom in there, let it suck it all up and out. Is this the type vent you are talking about? If it isn't, do you think it would work anyway?
You all can imagine how this place feels since the storm with 2-26/1-20/1-90/ & 1-125 all out here in the LR & DR. UG I feel like I am in a sauna.

Posted: Mon Jul 11, 2005 3:59 pm
by Brandon
I've seen a lot of people using the inline duct fans, they're a little pricy, but that's what I've been wanting to setup when I redo my tank.
like this:
They sell one at home depot for around $140 I think. If it will be in it's own room, I don't see why you couldn't just use a bathroom fan or a sidewall exhaust fan.. or maybe one of those duct booster fans they're very cheap.
Posted: Mon Jul 11, 2005 4:42 pm
by snoopdog
Posted: Mon Jul 11, 2005 6:44 pm
by snoopdog
If I remember right bathroom fans are expensive. Most bathroom fans are quite loud too, not something you want to hear all of the time by your tank. I am sure there are some quiet alternatives out there that are not expensive.
Posted: Mon Jul 11, 2005 9:17 pm
by Jahdiel
snoopdog wrote:If I remember right bathroom fans are expensive. Most bathroom fans are quite loud too, not something you want to hear all of the time by your tank. I am sure there are some quiet alternatives out there that are not expensive.
Actually we only paid about $40 for each of ours last year and they are fairly quiet. I don't think this would be an issue for us because the tank will be in the back room closet, with only the tank showing from the LR. My question would be, could they pull the humidity out well enough?
Posted: Tue Jul 12, 2005 7:28 am
by Snakeman
Why not get an Exhaust fan that you use over a stove?
Posted: Tue Jul 12, 2005 2:43 pm
by ShagMan
Snakeman wrote:Why not get an Exhaust fan that you use over a stove?
That's a good idea; in fact I was in H/D looking around, and they have ducting kits for retrofitting a hood that were really neat, came with all the ducting to exhaust the stuff...
Posted: Tue Jul 12, 2005 5:29 pm
by Brandon
For the speed of the fan look @ the CFM rating and then how many cubic feet your room is. Since you're mainly looking at getting the humidity out, I wouldn't think you would not want too much room turnover.
Could be wrong, but I don't think you need much turnover for it.